







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Winchester, NV: What the Job Actually Involves
A chain link fence in Winchester, NV typically runs $3,500 – $9,000 installed, with most infill lots in the 89109 ZIP landing between $4,200 and $6,800 for a standard 4-foot or 6-foot galvanized run. The work is usually two to three days on site: set posts and concrete on day one, stretch mesh and hang gates on day two, walk the line and tension everything on day three. Call (844) 797-5026 and we’ll price your specific run.
How We Build a Chain Link Fence Here, Start to Finish
Winchester is tight. Most of the lots we work sit behind a commercial frontage or in a dense multifamily block, so the sequence matters as much as the materials. Here’s the real order of operations.
- Day 1, walk and mark. We meet you on site, confirm the property line against your survey, and mark post spacing at 8 or 10 feet depending on height and wind load. You decide gate width, swing direction, and whether the run terminates at a building wall or a corner post. This takes about an hour, and it’s where most surprises get caught.
- Day 1, dig and set. We auger post holes to depth for your frost line and soil, set galvanized or powder-coated posts in concrete, and check plumb on every one. Terminal posts (corners, ends, gates) get larger diameter and deeper footings than line posts. In Winchester’s summer heat, we pour early morning and cover the footings, because concrete curing too fast in 105°F sun is a real failure point.
- Day 2, rails and mesh. Top rail and tension wire go on, then we stretch the chain link mesh with a come-along and tie it off at every post. Tensioning is where a fence lives or dies. Slack mesh sags within a season; properly stretched mesh stays tight for a decade or more.
- Day 2 or 3, gates and hardware. Gate frames, hinges, latches, and any operator get hung and adjusted. If you’re wiring a rolling-code gate operator for a driveway or side entrance, that electrical work happens here and you’ll walk through the remote programming before we leave.
- Day 3, cleanup and walk. We haul out spoils, grade the disturbed strip, and walk the full line with you. You sign off on tension, gate operation, and post alignment. That sign-off starts the 730-Day Done Right Promise.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Choices That Actually Change Your Fence
Chain link isn’t one product. The spec decisions below move both the price and how the finished fence looks and lasts.
- Height: 4, 5, or 6 feet. Four-foot keeps a residential side yard open and reads less institutional. Six-foot is the security standard and what most commercial and multifamily owners in Winchester pick. Every extra foot means larger posts and deeper footings.
- Gauge of mesh. 11.5-gauge is the residential workhorse; 9-gauge is heavier and resists cutting and bending far better. If security is the reason you’re fencing, 9-gauge is worth the upcharge.
- Galvanized vs. vinyl-coated. Bare galvanized is the cheapest and holds up fine in dry desert air. Vinyl-coated (black, green, or brown) costs more but reads softer against landscaping and hides the industrial look. In Winchester’s sun, both handle UV well; the coating is a looks decision more than a lifespan one.
- Top rail and tension wire. A top rail is standard on anything you’ll look at daily. Tension wire at the bottom keeps dogs and small animals from pushing under the mesh. Ask for both on the quote.
- Gate type and operators. Walk gates, double drive gates, and sliding gates each price differently, and a rolling-code operator with a keypad adds real money. Security-focused openers with rolling-code remotes are what we install on commercial and multifamily gates in Winchester, because fixed-code remotes are trivially cloned.
- Post finish. Standard galvanized posts are fine; powder-coated posts match a coated mesh and cost more. On a property where the fence is visible from the street, the match is worth it.
What a Chain Link Fence Costs in Winchester, NV

Expect $3,500 – $9,000 for a chain link fence in Winchester, and here’s what actually pushes your number toward one end or the other.
| Line Item | Typical Range |
|---|---|
| Standard 4′ galvanized run (per linear foot) | $18 – $28 |
| 6′ 9-gauge security run (per linear foot) | $28 – $42 |
| Walk gate, 3′ – 4′ | $300 – $650 |
| Double drive gate, 10′ – 12′ | $700 – $1,400 |
| Rolling-code gate operator with keypad | $1,200 – $2,800 |
| Demo and haul-off of existing fence | $400 – $1,200 |
Linear footage is the biggest lever. A 100-foot side yard and a 300-foot commercial perimeter are different jobs entirely. Soil and access come next: an infill lot with no room for a truck to pull in means hand-carrying materials, and that labor shows up in the price. Material grade (gauge, coating, post size) is the third variable, then gates and operators, then whether permits and any required inspections are in scope. A written estimate from us is line-item, fixed, and won’t change once work starts. What’s usually not included: landscaping repair beyond re-grading, electrical service upgrades to feed a gate operator, and any survey you don’t already have.
See the difference
Before
After
Before
After
Before
AfterWhat Winchester’s Lots Do to a Chain Link Fence
Winchester is unincorporated, wedged between the Strip and the airport, and that shapes everything about a fence job here. Permitting runs through Clark County, not a city building department, and projects near the resort corridor or airport-adjacent parcels carry height, glare, and dust-control sensitivities that a suburban lot never sees. Most of the 89109 stock is older low-rise commercial, motel-era buildings, and dense multifamily near the Strip, so fence runs often butt against a building wall on one side and a property line on the other with nothing resembling a normal setback. There’s typically no room for laydown, so deliveries and equipment staging have to be scheduled around traffic and business hours. The failure modes we see in Winchester look different from the suburbs: sun-baked galvanized posts that have lost their coating and started to chalk, mesh that’s stretched loose over a decade of wind, and gates sagging because the original footing was too shallow for a commercial-scale gate. Extreme summer heat and monsoon wind both take a toll on hardware and gate operators, and we plan installs around early-morning pours to beat the worst of it. If your project also involves relocating utilities or adding a structure, homeowners often pair this with ADU Site Prep & Utilities in Winchester so the site work is sequenced once. If you’re adding a back gate or a service door to a detached structure, Door Installation in Winchester is the same conversation. And when the fence is one piece of a bigger site plan, it’s part of a full Fence Installation in Winchester scope we can price together. We cover all of Winchester, and our Fence Installation service is where the broader lineup lives.
Serving Winchester, NV – Our Local Coverage Area
We serve Winchester and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Chain Link Fence in Winchester

Most Winchester chain link fence jobs take two to three days on site, with commercial perimeters of 300 feet or more running four to five. The schedule stretches if we need to demo an existing fence or schedule a gate operator install separately. Call (844) 797-5026 for a timeline on your specific run.
Permits depend on height and location, and any fence near the resort corridor or airport-adjacent parcels can trigger extra review through Clark County. We pull the permits that apply and schedule the inspections, so the fence is legal at final. Ask us to confirm what your address needs before you commit.
In most cases, yes. We locate buried utilities before we auger (the free 811 call handles that) and route post holes around irrigation and plantings where the layout allows. If a root ball or utility line sits exactly where a terminal post needs to go, we’ll show you the alternate layout on site and let you choose.
Chain link fence in Winchester runs $3,500 – $9,000 depending on linear footage, height, mesh gauge, gates, and access. A 100-foot residential run with one walk gate is usually under $5,000; a 6-foot 9-gauge commercial perimeter with a rolling-code operator is at the top of the range or above. Call (844) 797-5026 for an exact quote. Estimates are free.
Every chain link fence we install is covered by our 730-Day Done Right Promise: if it’s not done right, we make it right, for two full years on workmanship. Material warranties from the manufacturer pass through to you in writing. If a post heaves or a gate sags inside that window, we come back and fix it.
Get a Free Estimate on Your Chain Link Fence
Call (844) 797-5026 to schedule a free on-site estimate for a chain link fence in Winchester. We’ll walk the property line with you, measure the actual run, confirm gate placement and whether a rolling-code operator makes sense for your access, and hand you a written line-item quote with fixed pricing. A live person answers any hour of the day, so there’s no voicemail and no waiting. Most jobs are completed in a single visit.
Written by the team at Groundwork Construction Co.












