







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Asphalt Driveways & Resurfacing in Enterprise, NV: What It Takes and What It Costs
Asphalt Driveways & Resurfacing in Enterprise, NV runs $3,500 – $9,000 for a new paved drive and $250 – $700 for a reseal, with most 89139 tract lots landing somewhere in the middle. A new asphalt pour takes two working days: one to grade and compact the base, one to lay and roll the mat, then a short cure before you park on it. Resurfacing an existing drive is usually a single-day job. Call (844) 797-5026 and we’ll walk your driveway in person before anyone quotes a number.
How We Build or Resurface an Asphalt Drive in Enterprise

Asphalt work fails or succeeds on what happens before the blacktop shows up. Here’s the actual sequence, and where you make decisions.
Stage 1: Walk the site and probe the base (day 1, 60 – 90 minutes)
We measure the drive, check slope and drainage, and probe below grade. On Enterprise lots that means finding out fast whether caliche is sitting right under the surface. If the cemented hardpan is there, we plan a pre-rip with a larger machine instead of discovering it mid-excavation. You decide the driveway width and whether any widening is in scope. This is also where we confirm the driveway isn’t crossing a post-tension cable run in the slab foundation.
Stage 2: Excavate and prep the subgrade (day 1, 4 – 7 hours)
We strip the old surface or existing soil down 6 – 8 inches for a residential drive, then shape and compact the subgrade. Caliche layers get ripped and re-compacted rather than paved over; asphalt laid on unbroken hardpan cracks within a season. This is the slowest step and the one most crews skip. It’s also the step that decides whether your drive lasts six years or fifteen.
Stage 3: Base course and grading (day 1 – 2, 3 – 5 hours)
We lay and compact 4 – 6 inches of aggregate base, set the crown so water sheds to the street, and check fall against the garage slab. You’ll want the drive to sit roughly a quarter inch below the slab edge so runoff doesn’t run into the garage. Any low spot here becomes a puddle after a monsoon cell rolls through.
Stage 4: Hot-mix asphalt placement (day 2, 3 – 4 hours)
Two inches of hot-mix asphalt after compaction for a standard residential drive, three inches where a heavy truck or RV parks. We hand-lay edges and machine-roll the field. The mat needs air temperatures above roughly 50°F to place well, which is why summer pours in Enterprise start at dawn. You decide the finish: standard black, or a colored or stamped asphalt top if you want the look of pavers without the paver budget.
Stage 5: Cure, seal, and final walk (day 2 through day 30)
Light foot traffic is fine after 24 hours, vehicles after 48 – 72. Full cure takes about 30 days, and we seal somewhere between 6 and 12 months out once the oils have oxidized. You decide whether to schedule that first seal with us or wait. Either way you get a written walkthrough and the 730-Day Done Right Promise covering the workmanship.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The Options You’ll Choose Between
Most of the decisions on an asphalt drive come down to four calls. Here’s the honest trade-off on each.
- New asphalt pour vs. resurface over an existing base. A full pour runs $3,500 – $9,000 and gives you a clean, uniform surface. Resurfacing (an overlay over sound existing asphalt) costs less but only works if the base is still intact and the cracking is surface-level. If the base is shot, an overlay is money spent twice.
- Standard black vs. colored or stamped asphalt. Standard black is the cheapest per square foot and the easiest to patch later. Colored and stamped asphalt mimic the look of pavers for a fraction of a paver install, but the color fades faster under Mojave sun and re-sealing costs more.
- Two-inch vs. three-inch mat thickness. Two inches is fine for cars and light trucks. Three inches is worth the extra spend if anything heavier than a pickup parks there regularly. Thicker mats resist rutting better in summer heat.
- Sealcoat schedule. Sealing runs $250 – $700 depending on drive size. Every 2 – 3 years keeps the surface from oxidizing and drying out, which matters more here than in wetter climates because the sun does the damage, not the rain.
- Edge treatment. Exposed aggregate borders or a concrete apron at the street add cost but stop the asphalt edge from raveling where it meets the sidewalk or gutter.
If the driveway is one piece of a bigger front-yard project, that’s a different scope conversation – our Driveway & Pavers in Enterprise page covers the wider work.
What Asphalt Driveways & Resurfacing Costs in Enterprise, NV

Plan on $3,500 – $9,000 for a new asphalt driveway in Enterprise and $250 – $700 for a reseal. A full driveway replacement, which includes demo of the old surface, runs $5,000 – $14,000. Here’s how those numbers break down.
| Line item | Typical range |
|---|---|
| Asphalt driveway paving (new) | $3,500 – $9,000 |
| Driveway replacement (demo + new) | $5,000 – $14,000 |
| Driveway sealing / reseal | $250 – $700 |
Five things push a job toward the low or high end:
- Square footage. A single-car drive sits near the bottom; a three-car drive or one with an RV pad climbs toward $9,000.
- Caliche and site condition. Hitting hardpan means pre-ripping, which adds machine time. A soft, flat site needs none.
- Existing surface removal. Paving fresh on a graded lot is cheaper than tearing out old asphalt or concrete first.
- Mat thickness and finish. Three-inch mat and stamped or colored asphalt both add cost.
- Drainage corrections. If the drive needs a swale, channel drain, or re-grade to the street, that’s extra work and material.
Your written estimate lists grading, base, mat thickness, and finish line by line, with no change orders sneaking in later. Permits, if any are needed, are spelled out too. Call (844) 797-5026 for an exact quote; the on-site estimate is free.
See the difference
Before
After
Before
After
Before
AfterWhat Enterprise Homes Specifically Do to This Job
Enterprise is one of the fastest-built-out corners of the Las Vegas Valley, and asphalt work here looks different from a renovation market. The 89139 corridor south of the 215 beltway is dominated by tract and master-planned subdivisions built mostly between the 1990s and 2020s, so nearly every drive we price is either fresh on a new lot or watching a ten-to-twenty-year-old mat reach the end of its life. We see a lot of sun-cracked and oxidized asphalt on those first-generation subdivisions – the desert sun bakes the mat, the surface dries out, and once the binder goes, the cracks travel. Because so many homes sit on post-tensioned slab-on-grade foundations, every later trade that touches the ground has to know where the tensioned cables run before anything gets cut or trenched. Caliche is the other one. On a raw or partially graded 89139 lot, crews routinely hit cemented desert hardpan just below grade, and an asphalt drive that starts without pre-ripping it will fail fast. Summer triple-digit heat also forces scheduling: pours go early, hot-mix gets placed before the mat flashes, and we watch air temp against the mix. If you’re building around a new structure, homeowners often pair this with ADU Site Prep & Utilities in Enterprise when grading, trenching, and drainage are already on the table.
Serving Enterprise, NV – Our Local Coverage Area
We serve Enterprise and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked – Asphalt Driveways & Resurfacing in Enterprise

A new asphalt driveway usually takes two working days on site, with vehicles off it for 48 – 72 hours and full cure around 30 days. Resurfacing an existing drive is often a single day. We schedule the work around summer heat, so pours start early. Call (844) 797-5026 to get a date on the calendar.
Most residential driveway replacement and resurfacing in Enterprise does not need a permit, but anything that touches the street, changes curb, or alters drainage may. We confirm what applies to your lot before work starts rather than leave it to chance. Call (844) 797-5026 and we’ll tell you what your project needs.
You can resurface over existing asphalt if the base is sound and the cracking is only surface-level. If the base has failed or the drive is rutted and heaved, an overlay just hides the problem for a season. Resurfacing runs $250 – $700 for a reseal and less than a full pour for an overlay; a full replacement runs $5,000 – $14,000. Call (844) 797-5026 for a straight answer on which one your drive needs.
New asphalt paving in Enterprise runs $3,500 – $9,000, and sealing runs $250 – $700. Driveway replacement with demo included runs $5,000 – $14,000. Size, caliche, mat thickness, and drainage corrections move the number. Call (844) 797-5026 for an exact quote; estimates are free.
Every asphalt driveway we install is covered by our 730-Day Done Right Promise – if it’s not done right, we make it right. That’s two full years on workmanship, backed in writing, not a verbal handshake. Call (844) 797-5026 to see the terms before you commit.
Homeowners in Enterprise often pair a new drive with fencing to finish the front yard – if that’s your plan, our Chain Link Fence in Enterprise page covers the fence side, and our Driveway & Pavers hub has the full menu of driveway options for the Enterprise area.
Get Your Free Asphalt Driveway Estimate in Enterprise
Call (844) 797-5026 and a live person picks up, day or night. We’ll set a time to walk your driveway, probe the base, and check for caliche before we quote anything. You get a written line-item estimate with grading, base, mat, and finish spelled out – upfront pricing, no surprises. If you’re weighing options, we’ll tell you straight whether your drive needs a full pour or just a reseal, and we back the work with our 730-Day Done Right Promise.
Written by the team at Groundwork Construction Co.












