







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Chain Link Fence in Enterprise, NV: What It Costs and How Fast It Goes Up
A chain link fence in Enterprise, NV typically runs $3,500 – $9,000 for a residential yard, and most standard runs are finished in one to two days once the posts are set. The price depends on linear footage, height, gauge, gate count, and how much caliche the crew hits digging post holes. Call (844) 797-5026 for a free on-site estimate and a written line-item quote before anything gets ordered.
Stage by stage: how a chain link fence actually goes in

Chain link is one of the few fencing jobs where the whole sequence is predictable. Here’s what the days look like and where you make decisions.
Day 1 morning: layout and utility locating
We walk the property line with you and mark corners, gate positions, and any tie-ins to an existing fence or block wall. Before a single shovel goes in the ground, the 811 utility locate has to clear. On 89139 lots that matters more than people expect, because irrigation lines and pool plumbing in newer subdivisions run shallow and close to the wall lines. You’ll confirm the exact run and gate swing here; changing your mind after posts are set costs real money.
Day 1: digging and setting posts
Post holes go roughly 24 to 36 inches deep depending on height and wind exposure, then get filled with concrete. This is where Enterprise slows down. Caliche hardpan sits just below grade across much of the corridor south of the 215, and a two-man auger that eats through loose desert soil in minutes can stall on cemented hardpan. We plan for it. Posts cure overnight, so day one ends with a line of set posts and nothing else.
Day 2: rails, mesh, and tension
Top rail, tension bands, and the chain link mesh go up once the concrete has set enough to hold. Mesh gets stretched and tied off at each terminal post, and the bottom of the fabric is set at the grade you’ve chosen. If you’re running fabric to the ground for pet containment, that changes how the bottom rail and tension wire get installed. You’ll pick the mesh height and gauge before this stage, not during it.
Day 2 or 3: gates, hardware, and walkthrough
Walk gates and drive gates hang last, because the posts they mount to need the most cure time. Gate hardware is where cheap jobs show themselves: a sagging walk gate six months in almost always traces back to an undersized post or a hinge installed with the wrong anchor. We walk the finished fence with you, check every gate swing and latch, and hand over the workmanship coverage. That coverage is our 730-Day Done Right Promise, and if something isn’t right, we make it right.
Cleanup and haul-off
Old fencing, concrete spoil, and offcuts leave with us. On a full removal-and-replace, add a few hours to day one for tear-out. Inspections, where a permit requires one, get scheduled at the point of final inspection, which usually trails installation by a few days.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
The chain link options you’ll actually choose between
Chain link isn’t one product. These are the decisions that move both the look and the price.
- Gauge: 11.5-gauge is the residential standard and holds up fine in normal use. 9-gauge is noticeably heavier and harder to bend or cut, which matters if you’re securing a side yard or a dog run. It costs more per foot and weighs more to install.
- Height: 4-foot is common for marking a property line; 5 and 6-foot are the usual choice for backyard containment and privacy. Going taller adds material and demands deeper, better-braced posts.
- Coating: Galvanized steel is the baseline. Vinyl-coated (usually black or green) costs a bit more but looks cleaner against stucco and tile roofs, and it handles the desert sun better over the long haul without the gray chalky look bare galvanized picks up.
- Gate type: Walk gates with self-closing hinges are the everyday pick. Drive gates, double swing gates, and cantilever sliders for wide RV access are a different price tier and need heavier posts and framings.
- Top rail and tension wire: A top rail adds rigidity and a finished look. A bottom tension wire (instead of a bottom rail) keeps the fabric tight to the ground at lower cost.
- Privacy options: Slats woven into the mesh, or a fabric privacy screen, add cost but cut sightlines. Worth pricing if the fence faces a street or a neighbor’s second-story window.
Materials come from established manufacturers. Where we’re specifying coated systems, Atlas makes a solid line, and we’re happy to walk you through the difference in wall thickness and coating warranty between grades so the choice is yours, not ours.
What a Chain Link Fence costs in Enterprise, NV

For a typical residential yard in Enterprise, plan on $3,500 – $9,000 for chain link fence installation. That’s the full installed number, materials and labor, not a per-foot teaser.
Here’s what pushes a job toward the low or high end:
- Linear footage and height. A short side-yard run at 4 feet sits near the bottom. A full perimeter at 6 feet with several gates sits at the top.
- Existing fence removal. Tear-out and haul-off of an old fence adds labor and disposal cost.
- Site conditions. Caliche is the big one in Enterprise. Lots that need pre-ripping or extra excavation for post holes run higher.
- Gate count and type. Each drive gate or slider adds framing, hardware, and heavier posts.
- Permit scope. Where a permit and inspection apply, that’s a real line item. We tell you upfront whether your project needs one.
A written estimate from us lists footage, height, gauge, coating, gate count and type, removal, and permit status line by line. The number you see is the number you pay. What typically isn’t included: landscaping repair around posts, moving irrigation or sprinkler lines, and any concrete or masonry work at the base. We flag those separately so there are no surprises. If the fence is part of a bigger yard project, that’s where our Fence Installation in Enterprise work comes in, and we’ll scope it together. Financing is available at 0% for 18 months, and projects over $10,000 get $1,000 off.
See the difference
Before
After
Before
After
Before
AfterWhat Enterprise homes specifically do to this job
Enterprise is one of the fastest-built-out corners of the Las Vegas Valley, and that shapes chain link work here in ways it doesn’t in older parts of the valley. Housing in the 89139 corridor south of the 215 beltway is overwhelmingly recent tract and master-planned subdivision construction: wood-frame, stucco-clad, tile-roof homes on post-tensioned slab-on-grade foundations. There’s almost no historic stock to contend with. What you do get is raw desert being converted to rooftops, so fence lines often run along lots that were graded yesterday, with hardpan close to the surface.
Caliche is the local excavation headache. Crews hit cemented desert hardpan just below grade on many 89139 lots, and post-hole digging that should take minutes can stall without the right equipment. Another thing specific to these homes: post-tensioned slabs mean every trade that touches the ground has to know where the tensioned cables sit. For fence work it rarely comes up, but if you’re pairing the fence with a pad, a shed base, or utility trenching for an ADU, it absolutely does. Homeowners often pair this with ADU Site Prep & Utilities in Enterprise for exactly that reason. HOA review is common in the master-planned communities, and we’ll confirm fence height and coating color against your community rules before ordering material.
Serving Enterprise, NV – Our Local Coverage Area
We serve Enterprise and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently asked: Chain Link Fence in Enterprise

Most residential chain link runs take one to two days on site, plus cure time between setting posts and hanging gates. Larger perimeters, full removals, or heavy caliche can push it to three. Call (844) 797-5026 for a firm timeline based on your yard.
Permit requirements depend on fence height, location on the lot, and your community’s rules, so we check the specifics for your address rather than guess. Where a permit and inspection apply, we pull it and schedule the inspection as part of the job. Call (844) 797-5026 and we’ll tell you what your project needs.
Yes, in most cases. We call in the 811 utility locate before digging, and posts go in along the line without touching plumbing or structure. If a sprinkler or irrigation line sits in the post path, we flag it before excavation so you can decide whether to reroute. Call (844) 797-5026 to walk your line with us.
Expect $3,500 – $9,000 installed for a typical residential yard in Enterprise. The written quote is fixed: no change orders for conditions we could see at the estimate. If we hit something truly unexpected, like unmarked utilities or buried debris, we stop and talk to you before anything changes. Call (844) 797-5026 for your free estimate.
Every job is covered by our 730-Day Done Right Promise: if the workmanship isn’t right, we make it right. Manufacturer coverage on the mesh and hardware runs separately and depends on the grade and coating you choose. Call (844) 797-5026 with questions about coverage on a specific system.
Get a free chain link fence estimate in Enterprise
Call (844) 797-5026 and a live person answers, day or night. We’ll ask about your yard size, the height and gauge you have in mind, and whether an old fence comes out, then set a free on-site estimate. You get a written line-item quote, the permit picture for your address, and a start window. If the fence is part of a larger project, our Fence Installation service and Door Installation in Enterprise work pair cleanly with it. We cover all of Enterprise and the surrounding valley.
Written by the team at Groundwork Construction Co.












